Advertisement
MOUNTING/DISMOUNTING OF DOORS
In general, we recommend that you leave the dismounting of the door to the authorized dealer.
1. Close the door.
2. Loosen the screws
3. Remove the door.
Mounting is made in reverse order.
REPLACEMENT OF GLASS:
Dismount the door and place it on a plane surface with its back upwards. Remove all the screws of the inner
frame. Remove the inner door and replace the glass. Change the ceramic packing cord if necessary. Remount the
inner frame and remount the door on the cassette. Please note that the glass must not be firmly fixed.
MOUNTING OF THE CERAMIC SMOKE DEFLECTOR
A ceramic smoke deflector is delivered with all SCAN DSA cassettes. Place the smoke deflector plate according
to sketch 5; make sure that it is placed symmetrically in the cassette, i.e., with even amounts of free airspace on
each side.
By cleaning the chimney and pipe soot can fall down on the plate. Remove the soot by tipping the plate. The soot
will fall into the combustion chamber.
Note: Skamol is a porous material, and can break easily. The plate is a wearing part, and can/must be replaced
after some time. (The Skamol plate is not covered by the guarantee).
TROUBLE SHOOTING
Smoke:
The wood burns
too fast:
Sootend glass:
Sootend chimney:
The shaking grate
is stuck:
The cassette's surface
turns grey:
The cassette does not
heat:
- Insufficient chimney draught!
- Check if the chimney has the right dimension.
- Check if the smoke pipe or chimney is blocked.
- Check if the chimney has the right height compared to the surroundings.
- Is the combustion air and ash grate at the right position?
- Is there low pressure in the house (basement, ventilation, cooker hood)?
- Is the wood dry?
- Are the air valves adjusted correctly according to the instructions?
- Is the smoke deflector plate placed correctly?
- Is the combustion air valve adjusted according to the instructions?
- Is the wood dry?
- Is the chimney draught sufficient?
- Incorrect combustion!
- Is the wood dry?
- Are the air valves adjusted correctly according to the instructions?
- Check if a piece of wood, a pin or the like is stuck.
- Is the bar placed/mounted correctly?
- Over heating - please refer to maintenance instructions
- Use of moist wood. The energy is used to dry the wood.
5
Advertisement
