Workgroup - Muratec MFX-1430 Network Manual

WorkGroup

Enter an existing workgroup name to identify the group of computers that your
machine is associated with.
1
Open the SMB setting menu display. (Refer to page 2-10.)
2
Press [WorkGroup].
3
Enter an existing workgroup name.
NOTE: • If there is not a workgroup in your network, create a new workgroup by typ-
ing a new name that contains up to 15 characters. The name cannot include
symbols and/or blank spaces. The name can include alphanumeric characters
and the following symbols: ! @ # $ % ^ & ( ) – _ ` { } . ~
Consult with your network administrator before creating a new workgroup.
• A domain name cannot be used as a work group.
4
Press [Enter]. The display returns to the SMB setting menu.
You may configure additional settings.
To return to the Standby mode, press [Reset].
5
After you have completed registering the network settings, the machine
should be rebooted to enable the new settings. To reboot the machine, turn the
machine "Off" and after three or more seconds, turn the machine back "On"
Network settings
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
2-13