Table of Contents
Advertisement
en Troubleshooting
Fault
A message with
appears in the dis-
play, e.g. - .
lights up perman-
ently in the display.
lights up in the dis-
play.
appears in the
display.
The appliance hums
during operation and
after it is switched off.
During operation with
steam assistance,
steam escapes from
the ventilation slots.
After using the steam
assistance, the cook-
ing result is too dry
or too moist.
Home Connect is not
working properly.
19.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
30
Cause and troubleshooting
Electronics fault
1.
Press the
button.
If required, reset the time.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. Quote the exact error
2.
message and the E no. of your appliance.
→ "Customer Service", Page 31
The water tank is empty.
Fill the water tank.
▶
→ "Filling the water tank", Page 12
The water tank has not been put in fully.
Slide the water tank back in fully.
▶
The water tank is leaking.
Order a new water tank.
▶
The sensor is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 31
Build-up of limescale in the appliance.
Run the descaling programme in full.
▶
→ "Descaling", Page 23
The power supply has been disconnected or the appliance has been switched off during the
descaling process.
Run the interrupted descaling programme in full.
▶
→ "Descaling interrupted", Page 24
Functional test of the pump creates operating noise.
No action required.
Steam escapes for physical reasons.
Wait until the cooking with steam assistance ends.
▶
After the end of cooking with steam assistance, no more steam will escape after a short
time.
Steam intensity set incorrectly.
Set a higher or lower steam intensity.
▶
Different causes are possible.
Go to www.home-connect.com.
▶
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it .
2.
Advertisement
Table of Contents
