en Basic settings
Display
Basic setting
Waiting time until a setting is adopted
Button tone when pressing a button
Brightness of the display illumination
Time display
Childproof lock can be adjusted
→ "Childproof lock", Page 17
Interior lighting during operation
Cooling fan run-on time
Telescopic shelves retrofitted
Sabbath mode available
Water hardness
→ "Setting the water hardness", Page 18
Automatic rapid heating from 200 °C
Reset all values to factory settings
. .
Home Connect Settings
1
Factory setting (may vary according to model)
Depending on the appliance specifications
2
13.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold the button for approximately
1.
four seconds.
a The first basic setting appears in the display,
e.g. .
Use the temperature selector to change the setting.
2.
Use the or button to switch to the next basic set-
3.
ting.
To save the changes, press and hold the button
4.
for approx. four seconds.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
13.3 Discarding changes to the basic
settings
Turn the function selector.
▶
a All changes are discarded and not saved.
18
Selection
= 3 seconds
= 6 seconds
= 10 seconds
= off
= on
= dark
= medium
= bright
= hide the time
= display the time
= no
= yes
= no
= yes
= short
= medium
= long
= extra long
2
= no
= yes (for 2- and 3-level pull-out)
= no
= yes
= softened
= soft (up to 1.5 mmol/l)
= medium (1.5–2.5 mmol/l)
= hard (2.5–3.8 mmol/l)
= very hard (above 3.8 mmol/l)
2
= no
= yes
= no
= yes
→ "Home Connect ", Page 19
13.4 Setting the water hardness
ATTENTION!
If the wrong water hardness has been set, the appli-
ance cannot remind you to descale it at the right time.
▶
Using unsuitable liquids may damage the appliance.
▶
▶
Requirements
¡ Before you set the water hardness, ask your water
¡ The appliance must be switched off.
1.
a The first basic setting appears in the display,
2.
3.
1
1
1
1
1
1
1
1
(for rails and 1-level pull-out)
1
1
1
1
Set the water hardness correctly.
Do not use distilled water, highly chlorinated tap wa-
ter (>40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
non-carbonated mineral water.
supplier about the hardness of your tap water.
Press and hold the button for approximately
four seconds.
e.g. .
Use the or button to switch to the next basic set-
ting .
Use the temperature selector to set the water hard-
ness.