Table of Contents
Advertisement
en Shelf supports
Pour the descaling solution into the water tank and
2.
insert the water tank.
Use the function selector to set descaling .
3.
appears in the display.
a
Turn the temperature selector.
4.
a
appears in the display. Descaling starts after a
few seconds.
a At the end of the descaling programme, ap-
pears in the display.
Remove the water tank and clean thoroughly with
5.
water.
Second step ( )
Fill the water tank with 150 ml water and insert it.
1.
a At the end of the rinse cycle, appears in the
display.
Remove the water tank and clean thoroughly with
2.
water.
Third step ( )
Fill the water tank with 150 ml water and insert it.
1.
a At the end of the rinse cycle, appears in the
display.
Remove the water tank and clean thoroughly with
2.
water.
Fourth step ( )
1.
Fill the water tank with 150 ml water and insert it.
a At the end of the rinse cycle, : appears in the
display.
17 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
17.1 Detaching the shelf supports
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Lift the rail forwards slightly
1.
Pull the whole rail to the front
2.
Clean the rail.
3.
→ "Cleaning products", Page 21
24
and detach it
.
and remove it.
Remove the water tank and clean thoroughly with
2.
water.
Dry the water tank and re-insert it.
3.
a Descaling is complete and the appliance is ready
for use again.
Descaling interrupted
If descaling is interrupted (for example, due to a power
failure or because the appliance is switched off), the
symbol appears in the display after the appliance is
switched back on. You will be prompted to rinse three
times. The appliance cannot be used for other opera-
tions until the third rinse cycle comes to an end.
Note: If you set another operation, (Cleaning) ap-
pears in the display. Repeat the interrupted descaling
programme after rinsing.
Empty the water tank and clean thoroughly with wa-
1.
ter.
2.
Insert the empty water tank.
Use the function selector to set descaling .
3.
Turn the temperature selector.
4.
appears in the display.
a
a After a few seconds, the appliance pumps the re-
maining liquid into the water tank.
Empty the water tank and clean thoroughly with wa-
5.
ter.
To rinse the steam system, run the three rinse
6.
cycles in the descaling programme.
→ "Second step ( ) ", Page 24
Restart descaling.
7.
17.2 Attaching the shelf supports
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
First, push the rail into the middle of the rear
1.
socket until the rail rests against the cooking
compartment wall, and then push this back
Push the rail into the front socket
2.
also rests against the cooking compartment wall,
and then press this downwards
.
until the rail
.
Advertisement
Table of Contents
