Fcc Part 68 Telecom - Multitech RASFinder RF300E User Manual

FCC Part 68 Telecom

1. This equipment complies with Part 68 of the Federal Communications Commission (FCC) rules. On the
outside surface of this equipment is a label that contains, among other information, the FCC registration
number. This information must be provided to the telephone company.
2. As indicated below, the suitable jack (Universal Service Order Code connecting arrangement) for this
equipment is shown. If applicable, the facility interface codes (FIC) and service order codes (SOC) are
shown.
3. An FCC-compliant telephone cord with modular plug is provided with this equipment. This equipment is
designed to be connected to the phone network or premises wiring using a compatible modular jack which is
Part 68 compliant. See installation instructions for details.
4. The ringer equivalence number (REN) is used to determine the number of devices that may be connected
to the phone line. Excessive REN's on the phone line may result in the device not ringing in response to an
incoming call. In most, but not all areas, the sum of the REN's should not exceed (5.0). To be certain of the
number of devices that may be connected to the line, as determined by the total REN's, contact the local
phone company.
5. If this equipment causes harm to the phone network, the phone company will notify you in advance that
temporary discontinuance of service may be required. But if advance notice isn't practical, the phone
company will notify the customer as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
6. The phone company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the phone company will provide advance notice in
order for you to make necessary modifications in order to maintain uninterrupted service.
7. If trouble is experienced with this equipment (the model of which is indicated below) please contact Multi-
Tech Systems, Inc., at the address shown below for details of how to have repairs made. If the equipment is
causing harm to the network, the phone company may request that you remove the equipment from the
network until the problem is resolved.
8. No repairs are to be made by you. Repairs are to be made only by Multi-Tech Systems or its licensees.
Unauthorized repairs void registration and warranty.
9. This equipment should not be used on party lines or coin lines.
Manufacturer:
Trade name:
Model Numbers:
FCC Registration Number:
Ringer Equivalence:
Modular Jack:
Service Center in U.S.A.:
RF300E/RF310E
Multi-Tech Systems, Inc.
RASFinder
RF300E
AU7USA-24994-M5-E
0.6B
RJ-11C or RJ-11W
Multi-Tech Systems Inc.
2205 Woodale Drive
Mounds View, MN 55112
(612) 785-3500 Fax (612) 785-9874
Appendix C - Regulatory Information
119