XTline XT105319 User Manual page 17

Step three:
1. Place the Sanding Attachment( c) onto the Angle Grinder
c) Sanding Attachment
d) Clamps position
Note: the locating pin ofthe sanding attachment MOST be with the Gear
box's one(d) or the belt may have a risk of coming off.
Step four:
Pull the lever( e) to the left as the indicative Arrow. In this case, the shelf
will be narrowed.
e) ) Lever
Step five:
1. Place the Sanding belt onto the shelf. Ensure the
direction shown inside the belt(h, i) is consistent with
the direction printed on the shelf(f,g)
f. Indicating mark on the shelf
g. Indicating mark on the shelf
h. Indicating mark inside the belt
i. Indicating mark inside the belt
Step six:
Pull the lever back to the right,same
as the direction shown in the picture.
Step seven
1. Position the belt cover(j) onto the
shelf and tighten up the screw.
j) ) Belt cover
Step eight:
1. Screw the handle (k) onto the
attachment
k) handle