Cleaning Spraying Arms And Spray Nozzles; Complete Cleaning; Protection Against Frost Damage - Hanseatic WQP12-7735T User Manual

Page EN-26 Care and maintenance
Cleaning spraying arms and
spray nozzles
The spray nozzles and the nozzles in the
spraying arm may calcify or become dirty due
to food scraps. Check the nozzles regularly
and clean them if required.
1. Empty both racks and remove the lower
rack.
(31)
(32)
2. Pull the lower wash arm up and off.
3. The upper spraying arm is affixed using a
bayonet closure. To remove the spraying
arm, hold the two serrated bayonet grips
(45) still and turn the spraying arm clock-
wise.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after cleaning.
The spraying arm must be firmly affixed
and must be able to rotate freely.

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way from time to time.
When doing so, please note the manufactur-
er instructions on the packaging.
Protection against frost
damage
Position the dishwasher in a room which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
as follows. You will need a shallow dish or a
pan, and a sponge.
1. Disconnect the mains plug from the socket
(45)
or switch off the fuse.
2. Close the tap and unscrew the inlet hose
(39).
3. Let the water from the inlet hose flow
completely into the dish.
4. Remove the filters (34).
5. Remove the water from the sump floor
with the help of a sponge.