At Attention Code - Multitech ISIHI-2S User Manual

Command Implementation

AT Attention Code

Values: n/a
Default: n/a
AT precedes all command strings except the A/ command and escape codes.
A/ Repeat AT Command
Unit:
Values:
Default:
A/ repeats the AT command that was previously entered.
RETURN Command Execution
Values: n/a
Default: n/a
Press the RETURN (ENTER) key to carry out a command. The RETURN key is sometimes
abbreviated <cr> in command examples.
+++AT<cr> In-Band Escape Code
Values: ASCII
Default: + (43)
Sets the TA to enter command mode without disconnecting the call when it is online with a
remote device. The default escape code is three + characters, followed by AT, up to 80
command characters, and a RETURN (press ENTER). The TA escapes to command mode,
executes any commands in the string, and then remains in command mode. Use the S2= z
command to change the escape character.
<break>AT<cr> Out-of-Band Escape Code
Values: n/a
Default: n/a
Places the TA in command mode while remaining online. Enter a break signal, the letters AT,
up to 80 command characters, and a RETURN (press ENTER).
n/a
n/a
n/a
Chapter 5 - AT Commands
90