Table of Contents
Advertisement
14. The Add New Hardware Wizard Properties screen appears.
a.
In the Resource Settings field, select "Input/Output Range" and click on Change Setting.
The Edit Input/Output Range screen appears.
Select the value that matches the Base I/O Address value that you have already set on
the ISIHI board in Step 2. Click OK.
b.
In the Resource Settings field, select "Interrupt Request" and click on Change Setting.
The Edit Interrupt Request screen appears.
Select the value that matches the IRQ value that you have already set on the ISIHI
board in Step 2. Click OK. At the Resources tab, click OK again.
15. At the Start Hardware Installation screen, click Next.
16. A completion screen appears. Click Finish.
17. You will be prompted to restart your computer. Click Yes.
Chapter 3 - Software Installation
22
Advertisement
Table of Contents
Need help?
Do you have a question about the ISIHI-2S and is the answer not in the manual?