Table of Contents
Advertisement
3.13.1 Configuring Ports for NetWare Connect
When the driver is installed, it will allocate consecutive ports for the ISI card as follows:
•
16 consecutive ports for the ISIHP-4S/4U/4SD. Note that, for the ISIHP-4SD, only 8 of these ports will
be used; the other 8 ports will be considered "broken." After installation of the ISIHP-4SD is complete,
the "broken" ports can be allocated to a different purpose.
•
8 consecutive ports for the ISIHI-2S/2U or ISIHP-2S/2U
•
8 consecutive ports for the ISIHP-1S. However, upon inspection, the Netware OS will initialize the first
pair of ports (terminal adapters), label the second pair of ports "broken," initialize the third pair of ports
(modems), and label the fourth pair "broken." After installation of the ISIHP-1S card is complete, the
"broken" ports can be allocated to a different purpose.
To set up NetWare Connect ports, enter LOAD NWCCON at the NetWare console prompt. LOAD NWCCON
opens the NetWare Connect Configuration Utility. Select the appropriate menu options (modem type, speed,
flow control, etc.).
3.13.2 Removing the Driver (Novell)
In Novell, remove file AIOISIX.NLM from the system directory and make the appropriate changes to the
Autoexec.ncf file.
3.14 SCO Open Server 5 Driver Installation
The ISI driver for SCO Open Server 5 is shipped on CD-ROM (FAT file system) and can also be downloaded
from the Multi-Tech web site. In both cases, the driver files are compressed ("tarred"). Users installing from the
CD-ROM should begin at "To install from CD-ROM" directly below. Users installing from a floppy disk should
skip down to "To install driver from floppy disk" later in this section. The filename of the SCO5 driver in its
tarred form is sco50x.tar.
This present installation section is task-oriented with minimal explanation of procedural steps. The section
"Multi-Tech Installation Script" provides additional details to aid in installation.
3.14.1 Install from CD-ROM
1.
# mount -r /dev/cd0 /mnt
2.
# cd /mnt
3.
# cd servcard/drivers/sco50x
4.
#cp sco50x.tar /
5.
# cd <ENTER>
Chapter 3 - Software Installation
43
Advertisement
Table of Contents
Need help?
Do you have a question about the ISIHI-2S and is the answer not in the manual?