Table of Contents
Advertisement
7.
Close the Modems Properties dialog box. The message below appears asking if you want to configure
dial-up networking. Click Yes.
8.
The Remote Access Setup dialog box appears. Click Add.
9.
Each COM port appears in a separate Add RAS Device dialog box. To add the highlighted device, click
OK.
10. The Remote Access Setup dialog box displays again. Repeat steps 8 and 9 until all devices are added.
11. When all devices have been added, click Continue.
12. After the bindings have been reviewed and stored, you will be prompted to restart your computer. Click
Yes. You are now ready to configure the terminal adapters.
Chapter 3 - Software Installation
35
Advertisement
Table of Contents
Need help?
Do you have a question about the ISIHI-2S and is the answer not in the manual?