Table of Contents
Advertisement
Command:
&Wn
Store Current Configuration
Values:
n = 0 or 1
Default:
1
Description:
&W0
&W1
Command:
&Zy=x Store Dialing Command
Values:
y = 0–2 (0–1SMI-Parallel {internal})
x = Dialing command
Default:
None
Description:
Stores dialing command x in memory location y. Dial the stored number using the command
ATDS=y. See Also the #CBS command, a callback security command.
Command:
\An
Select Maximum MNP Block Size
Values:
n = 0, 1, 2, or 3
Default:
3
Description:
\A0 64-character maximum
\A1 128-character maximum
\A2 192-character maximum
\A3 256-character maximum
Command:
\Bn
Transmit Break
Values:
n = 0–9 in 100 ms units
Default:
3
Description:
In non-error-correction mode only, sends a break signal of the specified length to a remote
modem. Works in conjunction with the \K command.
Multi-Tech Systems, Inc. MultiAccess User Guide
Stores current modem settings in non-volatile memory and causes them to be
loaded at power-on or following the ATZ command instead of the factory defaults.
See &F command.
Clears user default settings from non-volatile memory and causes the factory
defaults to be loaded at power-on or following the ATZ command.
Appendix F – Modem AT Commands
59
Advertisement
Table of Contents
