Hardware Installation
Do not install the PCI Express board until the software has been fully installed.
The DIO-32.PCIe does not need to be configured prior to installation.
Once you have installed the SeaI/O Classic software, install the board into an available PCI Express slot
and boot the computer. The Found New Hardware wizard will appear. The drivers that were installed
during the software installation process will automatically be used to configure the adapter.
The following instructions are applicable to the Windows XP operating system and may vary depending
on your version of Windows.
1. After the software installation is complete, install the ISO-16.PCIe into an available PCI Express
slot and boot the computer.
2. A 'Found New Hardware' alert will appear above the system tray.
3. When the 'Found New Hardware' alert informs you that your hardware is installed and ready to use,
you can proceed with verifying the installation to check functionality if necessary.
© Sealevel Systems, Inc.
8004e Manual | SL9207 12/2022
8