Configuring The Faxfinder's Inbound Did Modem - Multitech FaxFinder FF110 Quick Start Manual

Server Installation
e. Email Server Authentication Parameters. If your email server
requires authentication in order to give the FaxFinder access, fill
in the three related SMTP fields (SMTP Server User ID, SMTP
Password, Retype SMTP Password). If you can enter the
network email program and send messages without entering a
User ID and Password, then you must leave these fields blank.
However, if your network email program does require a User ID
and Password in order to send email messages, you must fill in
these three fields. If authentication is required and these fields
are left blank, then the error "SMTP Authentication Error" will
appear on the Current Status screen in the "Email Status" field.
If authentication is not required and these fields are filled in,
then an error will also occur. You must know how your email
server works in this regard and complete the Administration:
SMTP Configuration screen accordingly.
f. If you do not receive an email saying that the mail server
address has been updated, see item #2 "What if I don't get an
email when I set the mail server address?" in the
Troubleshooting section of the Administrator User Guide.

8. Configuring the FaxFinder's Inbound DID Modem

The FaxFinder's DID Modem directs inbound faxes to client email
addresses.
a. In the FaxFinder Server software, go to the Modem
Configuration screen.
Multi-Tech FaxFinder Quick Start
16