Multitech FaxFinder FF120 Cabling Manual page 14

Cabling Instructions
3. Connect FaxFinder to Ethernet Network.
Plug one end of your RJ45 ethernet cable into the FaxFinder's
ethernet jack and the other end into your network ethernet hub.
This ethernet cable is not included with your FaxFinder unit.
LINE 1 LINE 2
FF-120/220
1 2 3 4 5 6 7 8
FF-420/820
Caution: Before connecting to the Ethernet Network, make sure
that the network to which you are connecting the FaxFinder is not
a 192.168.2.x subnet. Because the FaxFinder's factory default IP
address is 192.168.2.1, connecting it to a network that has a
different device at that same IP address would cause data
interference.
If it is a 192.168.2.x subnet, connect from the Administrative PC
to the FaxFinder using an RJ45 crossover cable until the
FaxFinder's IP address has been configured. Thereafter, connect
the FaxFinder into the network with an ordinary RJ45 cable.
14
FaxFinder Cabling Guide
Ethernet
Receptacle
LAN 1
CONSOLE
RESET
ETHERNET
COMMAND
MultiTech Systems, Inc.