8.4
Installation with a surface-type housing 6885
● Break up one of the side covers (item 1) or
one of the covers in the base plate (item 2)
depending on the desired wiring arrangement.
● If necessary, install a cable entry.
● Insert the required cables into the surface-
type housing.
● Fasten the surface-type housing with some
screws.
● Connect the flush-mounting insert as shown in
the connection diagrams (see Fig. 1 to 10)
and fasten it to the nuts (item 3) provided in
the surface-type housing.
8.5
Installation in combination with extension units
The Presence Watchdog can be operated via extension units. Please comply
with the instructions in the operating manual of your specific flush-mounting
insert concerning the wiring arrangement, the maximum cable length, the
selection of normally-open contact buttons, etc.
8.6
Dismounting the Presence Watchdog
Pull the Presence Watchdog perpendicularly down at the outer housing ring to
remove it from the flush-mounting insert.
19 ENG
Fig. 16