Table of Contents
Advertisement
2.4.1 Power Supply Installation
The CC1600-series modem rack is configured with either a single power supply or two (hot-swappable,
redundant) power supplies. A single power supply can maintain a full complement of 16 modems or DSUs.
To install a power supply, perform the following procedure.
1.
Unpack the power supply and check for visible shipping damage. If damage is observed, do not install
the power supply; contact Multi-Tech's Technical Support for advice (refer to Chapter 3).
2.
Using a Phillips screwdriver, loosen the two power supply cover mounting screws and remove the cover
from the slot where you intend to install the power supply.
3.
Slide the power supply into the two mating card guides and firmly seat the power supply connectors into
the backplane connectors.
4.
With a Phillips screwdriver, tighten the power supply screws.
Warning!
If only a single power supply is used, then the unused opening should have a power supply
cover in place.
5.
If a second power supply is being installed, repeat steps 1 through 4.
6.
Return to the rack installation procedure to continue installing the rack.
Power Supply
1
0
Figure 2-3. Power Supply Installation
Chapter 2 - Installation
Power Supply
Cover
13
Advertisement
Table of Contents
