Microlife aponorm Mobil Slim Manual page 25

8. Press the ON/OFF button 1 to start the measurement.
9. The LED positioning indicator 8 switches on automatically.
Support your arm in a relaxed position at about the same height
as your heart and slightly move your arm until the LED light is
brightest and located in the centre of the positioning indicator.
10. The measurement will begin after 3 seconds, and the cuff will
inflate automatically. It is completely normal that the pumping
speed slows down. Relax, do not move and do not tense your arm
muscles until the measurement result is displayed. Breathe
normally and do not talk.
11. The measurement is performed while the cuff inflates. The
pumping speed can vary, which is completely normal.
12. During the measurement the pulse indicator 17 in the display
is flashing.
13. The result, comprising the systolic 9 and the diastolic 10 blood
pressure and the pulse rate 11 is displayed. Note also the
explanations on further display symbols in this booklet.
14. Remove and switch off the monitor (the monitor will switch off
automatic-ally after approx. 1 minute) and enter the result in the
enclosed blood pressure pass.
You can stop the measurement at any time by pressing the
ON/OFF button (e.g. if you feel unwell or the pressure of the
cuff becomes unpleasant).
EN
25