Hyundai HL970A Operator's Manual page 41

Cautions to Be Taken When Driving the Machine
If you operate the machine with the parking brake on, it
may cause serious damage to the parking brake disk.
Select the appropriate gear for the driving speed.
Do not change direction when driving the machine at
max. speed as this may cause serious damage to the
transmission.
Only drive the machine for short distances on the road.
Make sure you fully comply with the local road traffic
regulations and legislation of your country when driving on
the road.
Please note that the machine is wider and travels at a
lower driving speed than other vehicles on the roads.
Pay attention to any vehicles behind your vehicle, and
allow them to overtake your vehicle safely.
Check the following conditions before driving the machine
on the public road :
-
Remove any dirt and sand from the machine.
-
Empty the bucket and move it to the driving position (40~
50 cm above the ground) and fix it.
-
Close the windshield. Turn the working light off.
-
Wear the seat belt.
-
Use the lighting devices, such as the headlights, emergency
warning light and rotating beacon, pursuant to the local
road traffic legislation.
-
Pay attention to people in the vicinity of the machine.
-
Do not operate the machine on roads or bridges where
the machine exceeds the weight limit.
-
Familiarize yourself fully with the width, length and height
of the machine.
-
Check the tire pressure.
-
When traveling for a long distance, stop the machine
after every 40 km or on an hourly basis, and take a
break.
-
Check the level of fuel and coolant.
-
Never shift the gear to the neutral position when driving
down a slope.
-
Changing direction when operating the machine on a
slope is dangerous.
-
Do not drive on a slope of 30˚ or more.
-
Drive slowly when traveling the machine on rough terrain
or moving over obstacles.
-
Install chains on the tires when operating the machine
on slippery roads covered with snow or rainwater, and do
not attempt to start, stop or turn the machine suddenly.
-
Be sure to avoid any obstacles when traveling the
machine on paths.
Driving position
1-21