Traveling Of The Machine - Hyundai HL970A Operator's Manual

6. TRAVELING OF THE MACHINE

6. TRAVELING OF THE MACHINE
1) 1) BASIC OPERATION BASIC OPERATION
※
Secure the engine hood in the fully closed Secure the engine hood in the fully closed
position prior to traveling the machine. position prior to traveling the machine.
(1) (1) Traveling posture Traveling posture
Lift the boom so that the bucket is placed
40-50cm above the ground.
(2) (2) Traveling operation Traveling operation
When warm-up operation is completed after the
engine is started, move the machine according
to the following procedure.
①
Push the pilot cut off switch to the ON position.
②
Release the parking brake.
③
Put the gear selector lever in the 1st stage of
forward or backward direction and press gently
the accelerator pedal to move the machine.
(3) (3) Changing direction and speed Changing direction and speed
①
The gear selector is designed for the mounting
on the left side of the steering column.
②
The positions (speeds) 1 to 4 are selected by a
rotary motion, the driving direction Forward
(F)-Neutral (N)-Reverse (R) by tilting the gear
selector lever.
③
A neutral lock is installed as protection against
inadvertent drive off.
·Position N - Gear selector lever blocked in
this position
·Position D - Driving
④
When doing digging or dumping work, run the
machine in the 1st or 2nd speed.
40~50cm
Gear selector lever
Parking brake switch
Pilot cut off switch
Acceleration
Deceleration
4-10
960A4OP10
Release
ON
760F4OP14
Forward
F
N
R
Reverse
N D
77074OP33