Hyundai HL970A Operator's Manual page 15

23) 23) START PROCEDURE START PROCEDURE (item 32)
This warning label is positioned on the right
side window of the cab.
24) 24) DIESEL EXHAUST FLUID (item 33) DIESEL EXHAUST FLUID
This warning label is positioned on the right
side of the rear frame.
※
Fill only the DEF/AdBlue® (Diesel Fill only the DEF/AdBlue
Exhaust Fluid, standardised as ISO Exhaust Fluid, standardised as ISO
22241). 22241).
Aqueous urea solution made with 32.5% Aqueous urea solution made with 32.5%
high-purity urea and 67.5% deionized high-purity urea and 67.5% deionized
water. water.
※
Do not fill the diesel fuel. Do not fill the diesel fuel.
ACCUMULATOR (item 39) ACCUMULATOR
25) 25)
This warning label is positioned on the
accumulator of the solenoid valve.
※
The accumulator is filled with high-pres- The accumulator is filled with high-pres-
sure nitrogen gas, and it is extremely sure nitrogen gas, and it is extremely
dangerous if it is handled in the wrong dangerous if it is handled in the wrong
way. Always observe the following pre- way. Always observe the following pre-
cautions. cautions.
Never make any hole in the accumulator Never make any hole in the accumulator
expose it to flame or fire. expose it to flame or fire.
※
Do not weld anything to the accumulator. Do not weld anything to the accumulator.
When carrying out disassembly or main- When carrying out disassembly or main-
tenance of the accumulator, or when dis- tenance of the accumulator, or when dis-
posing of the accumulator, it is neces- posing of the accumulator, it is neces-
sary to release the gas from the accu- sary to release the gas from the accu-
mulator. A special air bleed valve is nec- mulator. A special air bleed valve is nec-
essary for this operation, so please con- essary for this operation, so please con-
tact your Hyundai distributor. tact your Hyundai distributor.
1. Start ignition on.
2. Wait up to 4 seconds for grid heater operation in summer.
(45 seconds in winter)
3. Start cranking.
4. If engine still does not start, turn the Keyswitch to OFF position.
5. Loosen fuel supply line at the outlet of pre-filter.
6. Do hand-priming repeatedly until air bubbles comes out from
fuel supply line completely.
7. Tighten fuel supply line to its origin position.
8. Recranking.
9. If the engine still would not start,
please contact the nearest HYUNDAI or Cummins dealers.
(Diesel
0-13
Start Procedure
7609A0FW07
760F0FW13
1107A0FW46