Transportation And Storage; Further Information - Siemens SITRANS F Operating Instructions Manual

Introduction

1.9 Further Information

1.8

Transportation and storage

To guarantee sufficient protection during transport and storage, observe the following:
• Keep the original packaging for subsequent transportation.
• Devices/replacement parts should be returned in their original packaging.
• If the original packaging is no longer available, ensure that all shipments are properly
packaged to provide sufficient protection during transport. Siemens cannot assume liability
for any costs associated with transportation damages.
Special conditions for storage and transportation of the device are listed in Technical
specifications (Page 77).
Identification
Note
IMPORTANT
This device is NOT to be used in hazardous areas.
CE declaration is delivered with the device.
Transmitter model number is: FST020
The system ordering code represents the transmitter including accessories.
AC System ordering code: 7ME3570-1JA4XXXXXX
DC System ordering code: 7ME3570-1JB4XXXXXX
AC - Transmitter ordering code: 7ME3570 - 1JA40-0AA1
DC - Transmitter ordering code: 7ME3570 - 1JB40-0AA1
1.9 Further Information
Product information on the Internet
The Operating Instructions are available on the documentation disk shipped with the device,
and on the Internet on the Siemens homepage, where further information on the range of
SITRANS F flowmeters may also be found:
Product information on the internet (http://www.siemens.com/flow)
10
NOTICE
Insufficient protection during storage
The packaging only provides limited protection against moisture and infiltration.
• Provide additional packaging as necessary.
SITRANS FST020 IP65 (NEMA 4X)
Operating Instructions, 05/2022, A5E41425845-AC