Integrating A Hart Device In A Hart Modem Network - Siemens SITRANS F Operating Instructions Manual

– To change the device address, select the inserted Modbus device in the right window and
– Start SIMATIC PDM by double-clicking the newly inserted Modbus device in the right
Note
Multiple PCs in one project
If there are several PCs in your project, you have to define one of them as the current one. To do
this, select the desired PC object in the left window and then select the menu command Options
→ Define Current PC.
C.1.6

Integrating a HART device in a HART modem network

Figure C-3
The following describes how to integrate a HART device in a HART modem network.
Requirements
• A project has been created.
• An access point of the computer is set to the COM port to which the HART modem network
is connected.
SITRANS FST020 IP65 (NEMA 4X)
Operating Instructions, 05/2022, A5E41425845-AC
then select the Object Properties menu command in the shortcut menu. Select the
Communication tab in the displayed dialog and enter the new short address.
window. Select the relevant device in the menu tree (only required for the first call), and
assign parameters for the device.
Figure C-2 Set COM port
HART modem
C.1 Commissioning with SIMATIC PDM
SIMATIC PDM
105