Siemens SITRANS F Operating Instructions Manual page 107

8. To set the device address, select the inserted Modbus device in the right window and right-
click. Select the Object Properties command in the displayed shortcut menu.
9. Enter the device-specific information (Modbus address 0-247) in the Communication tab of
the Properties dialog for the HART device.
Note
Address with HART
• The short address must be entered for HART devices. This address must correspond to the
• For a HART interface, enter the long address. This address contains the following device-
10.To change the device address, select the inserted HART device in the right window and then
select the Object properties menu command in the shortcut menu. Select the
"Communication" tab in the displayed dialog and enter the new short address.
Note
The address must correspond to the connected device. The short address for HART devices is
always "0" unless the device is in the multi-drop function.
11.Start SIMATIC PDM by double-clicking the newly inserted HART device in the right window.
Select the relevant device in the menu tree (only required for the first call), and assign
parameters for the device.
Figure C-5
Note
Multiple PCs in one project
If there are several PCs in your project, you have to define one of them as the current one. To do
this, select the desired PC object in the left window and then select the menu command Options
→ Define Current PC.
SITRANS FST020 IP65 (NEMA 4X)
Operating Instructions, 05/2022, A5E41425845-AC
connected HART device. The short address is always "0", unless the device is in the multi-
drop function.
specific information:
– Manufacturer
– Device type
– Device name
Set COM port
C.1 Commissioning with SIMATIC PDM
SIMATIC PDM
107