Ejoy RD
| Electric wheelchair
Ejoy RD XL
| Electric wheelchair
Ejoy RD XXL
| Electric wheelchair
The horizontal adjustment works as follows:
•
Push the locking lever forwards
•
by lifting or lowering the footplate receiver tube you can move the
legrest to the required position
•
Release the locking lever; legrest locks into place automatically.
Never stand on the footplate and when
swinging it away, watch your fingers
as there is a risk of pinching.
To change seat, the legrest must be
swung away or removed. Never sit on
the legrest. Risk of tipping over!
6.
Footplate angle
•
Adjusting the footplate is exactly the same as for the mechanical
legrests (see Chapter 3.5.1).
Height of the calf pad
•
The height of the calf pad is variable.
•
Loosen the screw fixing on the side of the legrest.
7.
•
Adjust the calf pad to the required height (Fig. 6).
•
Re-tighten the screws.
Depth of the calf pad
•
The depth of the calf pad is variable.
•
Loosen the screw fixing on the side of the calf pad.
•
Adjust the calf pad to the required depth (Fig. 7).
•
Re-tighten the screws.
74
Electric wheelchair |
Electric wheelchair |
3.5.3. Electronic legrests (optional)
Lower leg length
The lower leg length can be adjusted in eight steps.
•
To do this, loosen the Allen screw and then pull it out,
•
adjust to the required height,
•
re-tighten the screw.
Footplate angle
•
Adjusting the footplate is exactly the same as for the mechanical
legrests (see Chapter 3.5.1).
Make sure there is a reasonable gap
between footrests and the floor.
Height of the calf pad
•
Adjusting the calf pad is the same as for the horizontally adjustable
leg support (see Chapter 3.5.2).
3.5.4. Seat
Seat width
Adjusting the seat width:
•
Make sure that the wheelchair is switched off.
•
Remove the attachments such as the back cushion and seat pad.
The back cushion and seat pad are secured with hook and loop
fastenings to prevent them slipping.
•
Loosen the hook and loop fastener of the backrest sling and remove
it (Fig. 8/9).
•
Remove both fixing screws on the sleeve of the push handle (Fig. 9).
•
Then loosen the front and rear screws on the underside of the seat
surface (Fig. 10/11).
•
First adjust one of the seat halves (left or right) and then the other
one after that. When moving the seat halves, make sure that the
sleeve on the push handle (Fig. 9) does not tilt during the proce-
Bischoff & Bischoff GmbH - 2022-12-19 - Revision: 2
Ejoy RD
Electric wheelchair |
Ejoy RD XL
Ejoy RD XXL
8.
9.
10.
11.
75