Advertisement
Installing the Handle
1.
Use the bolts and nuts that your removed in step
5
in
Removing the Handle (page 2)
handle to the handle mount; refer to
2.
Install any wire-harness connections to the
connections on the handle
1. Throttle hardware
3.
Install the hardware that you removed in step
in
Removing the Handle (page 2)
throttle arm to the handle
4.
Install the panel to the handle with the screws
that you removed in step
Handle (page
2); refer to
to secure the
Figure
(Figure
8).
Figure 8
2. Wire-harness connection
to secure the
(Figure
8).
1
in
Removing the
Figure
3.
4
5.
Installing the Control-Shaft
Connector
Parts needed for this procedure:
1
Control-shaft connector
Procedure
Refer to
Figure 9
g287674
2
1. Control-shaft connector
(clutch bail)
2. Pin
1.
Disconnect the traction-cable spring from the
control-shaft connector.
2.
Remove the connector by removing the pins that
secure the connector to the control shaft
3.
Use the pins to install the new control-shaft
connector to the control shaft.
4
for this procedure.
Figure 9
3. Traction-cable spring
4. Control-shaft connector
(traction lever)
g287669
Advertisement
