Advertisement
6
Adjusting the
Bail-Latch-Spacer Position
No Parts Required
Procedure
Adjust the bail-latch-spacer position so that the spacer
is between the bail latch and the upper chassis tab;
refer to "B" in
Figure
11.
1. Shoulder bolt
2. Spacer
3. Nut
1.
Remove the spring from the bail latch.
2.
Loosen and remove the shoulder bolt and nut
that secure the bail latch to the chassis tab.
3.
Use the shoulder bolt, nut, and spacer to secure
the bail latch to the control shaft.
4.
Install the spring to the bail latch.
Figure 11
4. Bail latch
5. Spring
7
Installing the Wire Harness
and Interlock Module
Parts needed for this procedure:
1
Wire harness
1
Interlock module
2
Screw
Procedure
1.
Use 2 screws to install the interlock module to
the cable bulkhead
1. Screw
2. Interlock module
2.
Install the wire harness as follows:
•
Wire-harness end with the 6-socket
connector: install to the interlock module.
g287718
•
Wire-harness end labeled T
install to the proximity-sensor connector.
•
Wire-harness end labeled T
install to the machine-wire-harness end
labeled T
6
(Figure
12).
Figure 12
3. Cable bulkhead
RACTION
M
O
AIN
I
M
.
O
NTERLOCK
ODULE
g281730
S
:
WITCH
H
:
ARNESS
Advertisement
