Preparing The Machine - Toro 139-4330 Installation Instructions Manual

1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine.
4. Remove the spark-plug wire from the spark plug;
refer to your machine Operator's Manual.
2
Removing the Control
Cover
No Parts Required
Procedure
1. Disconnect the wire-harness connector from the
hour meter (Figure
1. Wire-harness connector
2. Remove the control cover by removing the
screws that secure the control cover to the rear
panel (Figure 2).
1).
Figure 1
2. Hour meter
1. Screw
3
Removing the Clutch Bail
No Parts Required
Removing the Handle
1. Remove the screws that secure the panel to the
handle and remove the panel from the handle
(Figure 3).
g280735
1. Handle
2. Screw
2
Figure 2
2. Control cover
Figure 3
3. Panel
g280734
g287538