Toro 139-4330 Installation Instructions Manual page 5

4. Connect the traction-cable spring to the new
connector.
5
Installing the
Proximity-Sensor
Assembly
Parts needed for this procedure:
1 Proximity-sensor assembly
2 Flange nut (1/4 inch)
2 Double-ended screw
Procedure
1. Remove the socket-head screws from the
spacer on the control shaft
2. Use 2 double-ended screws and 2 flange
nuts (1/4 inch) to secure the proximity-sensor
assembly to the control shaft
3. Torque the screws and nuts to 9 to 12 N∙m (7
to 9 ft-lb).
(Figure 10).
(Figure 10).
1. Spacer
2. Socket-head screw
3. Proximity-sensor
assembly
5
Figure 10
4. Double-ended screw
5. Flange nut (1/4 inch)
g287673