Figure 17
1. Grass deector frame
6. Place the rear hook over the rear of the
mounting bracket (Figure 18).
7. Install the upper tube into the bagger
(Figure 18).
8. Slide the clamp onto the middle tube
(Figure 18).
9. Align the knob on the middle tube with the
notch in the upper tube. Slide the middle tube
into the upper tube and twist the middle tube
60 degrees (Figure 18).
10. Tighten the clamp around the upper and
middle tube connection (Figure 18).
11. Slide the middle tube onto the boot and latch
them together (Figure 18).
2. Grind this part off
Figure 18
1. Boot
2. Middle tube
3. Knob
4. Upper tube
5. Latch
6. Notch in upper tube
Step
11
Installing the Bagger Dump
Handle
Parts needed for this step:
1
Dump handle
2
Washers, 13/16 inch
1
Cotter pin
Procedure
1. Unfasten the dump handle from the crate.
2. Install a washer onto the bagger dump handle
and install the bagger dump handle into the
bagger frame (Figure 19).
3. Fasten the bagger with a washer (13/16
inches) and a cotter pin (Figure 19).
15
7. Mounting bracket
8. Front slot
9. Rear hook
10. Front hook
11. Clamp