Advertisement
Menus, Configuration, and Adjustments
The PowerCage 411 FOX3 Enclosure has a menu system consisting of four main menus that are selected by pressing the front
panel MENU button (see figure 3,
the front panel NEXT button (
adjustments. See the following flowcharts:
Extron
Power
PowerCage 411
On
60-1492-02
FW v1.00.xxx
Menu
SLOT MENU
Menu
FRAME STATUS
MENU
Menu
VIEW COMM
SETTINGS MENU
Menu
EXIT MENU
Menu
Remote Control
The PowerCage 411 can be configured and controlled remotely using Simple Instruction Set (SIS) commands, Product
Configuration Software (PCS), and the internal web pages.
NOTE:
For details on all the remote control options, see the PowerCage 411 Series User Guide and PowerCage 411 Series
PCS Help File.
Simple Instruction Set (SIS) Commands
Use SIS commands for operation and configuration of the PowerCage. Run these commands from a PC connected to:
•
A LAN or WAN using the rear panel RJ-45 LAN connector (see figure 1,
•
The Remote RS-232 port (see figure 1,
•
The front panel USB config port (see figure 3,
22023.
Product Configuration Software (PCS)
Another way to operate the PowerCage is via PCS, which runs on computers that use the Windows
program is available at www.extron.com. PCS can be run from a PC connected to the rear panel LAN port (see figure 1,
front panel configuration port (see figure 3,
NOTE:
An Extron Insider account is required to download and use PCS. Contact an Extron support representative to obtain
an Insider Account.
Internal Web Pages
Another way to configure and operate the switcher is via its factory-installed internal web pages. The pre-loaded web pages
on the PowerCage are accessible through the LAN port (see figure 1,
config port (see figure 3,
NOTE:
Compatible web browsers are Microsoft
G
on page 2). Each main menu consists of submenus that are accessed by pressing
G
). Use the front panel Horizontal and Vertical Adjust knobs (
Default
Cycle
Power
PowerCage 411
On
60-1492-02
FW v1.00.xxx
Next
D
) via DataViewer.
D
D
) on the PowerCage.
D
) using a web browser.
Edge
®
Extron
Default Cycle
Slot #1
Slot #2
Fox3 T 301
N/A
C
on page 1) via an SSH client and port 22023.
on page 2) via an SSH client and IP address 203.0.113.22 and port
C
) via a LAN or WAN connection or the front panel USB
, Mozilla
Firefox
, Google Chrome™, and Apple
®
®
®
H
) to make any submenu
Slot #3
Slot #4
Fox3 T 311
FOX3 T 201
Menu
®
operating system. This
Safari
®
SLOT MENU
C
) or
.
®
3
Advertisement
