Repairing The Recording Media - JVC CONNECTED CAM GY-HC500U Instructions Manual

5 Formatting starts.
Formatting...
.
6 Formatting is complete.
When formatting is complete, "Complete" appears
and the camera recorder returns to the [Format
Media] screen.
Memo :
The menu cannot be operated while formatting
0
is in progress, but recording is possible to the
slot where formatting is not executed.
Formatting cannot be performed in the following
0
cases.
When recording to the recording media to be
0
formatted is in progress.
SD card is not inserted.
0
Write-protect switch of the SD card is set (z
0
is displayed).
Caution :
If you format a recording media, all data
0
recorded to it, including video data and setup
files, will be deleted.

Repairing the Recording Media

It is necessary to restore the recording media if an
abnormality occurs to the data in the recording
media due to some reasons.
Memo :
[！RESTORE] appears in the remaining level
0
display area when a recording media that
requires repair is inserted.
1 Select [System] B [Media] B [Restore
Media].
(A P154 [ Restore Media ] )
52
Recording Media
2 Select the recording media to be restored
and press the Set button (R).
.
3 Restoring starts.
Restoring...
.
4 Restoring is complete.
When restoring is complete, "Complete"
0
appears and the camera recorder returns to the
[Restore Media] screen.
When no media that requires restoring is
0
inserted, the camera recorder returns to the
[Media] menu screen.
Caution :
[Restore Media] can only be selected in Camera
0
mode. However, it cannot be selected while the
camera recorder is recording. Select [Restore
Media] in Camera mode when the camera
recorder is not recording.
[Restore Media] does not restore the SD card to
0
its original states completely. If restoring fails,
replace or format the recording media. Take
note that formatting erases all the information
inside the SD card.
Restoring cannot be performed in the following
0
cases.
Camera recorder is recording in progress.
0
SD card is not inserted.
0
Write-protect switch of the SD card is set (z
0
is displayed).
2