JVC CONNECTED CAM GY-HC500U Instructions Manual page 93

3 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECL" B
"STBYL" (yellow text)).
The card slot status indicator remains lighted
0
in red.
Memo :
When the [CANCEL] button is pressed while the
0
camera recorder is paused (STBYL), the
display changes ("STBYL" (yellow text) B
"STBYL" (blinking yellow text) B "STBYL"
(white text)), and a "clip" is generated. The card
slot status indicator lights up in green.
4 Resume recording. (Recording 2)
Press the [REC] button again to resume
0
recording. The display changes ("STBYL"
(yellow text) B "RRECL").
The card slot status indicator remains lighted
0
in red.
5 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECL" B
"STBYL" (yellow text)).
The card slot status indicator remains lighted
0
in red.
6 Resume recording. (Recording 3)
Press the [REC] button again to resume
0
recording. The display changes ("STBYL"
(yellow text) B "RRECL").
The card slot status indicator remains lighted
0
in red.
7 Press and hold the [REC] button.
Recording stops and the display changes
0
("RRECL" B "STBYL"). A "clip" is generated.
The card slot status indicator lights up in
0
green.
8 Press the [REC] button again.
The display changes ("STBYL" B "RRECL")
0
and the card slot status indicator lights up in
red.
A new "clip" is generated from here.
0
Memo :
The following operations cannot be performed
0
while recording is paused (STBYL, yellow text).
Clip Review operation
0
(A P86 [Viewing Recorded Videos
Immediately (Clip Review)] )
Switching SD card slots
0
Switching operation mode
0
(A P24 [Operation Modes] )
Files are split into sizes of 4 GB (or 30 minutes)
0
regardless of the menu settings.
Caution :
Do not remove the SD card during recording
0
(RRECL, red text) or recording pause (STBYL,
yellow text).
To remove the SD card in the "Clip Continuous"
0
mode, press the [CANCEL] button, check that
"STBYL" (white text) is displayed and the card
slot status indicator lights up in green before you
remove the card.
To remove the SD card in the "Clip Continuous"
0
mode, press the [CANCEL] button, check that
"STBYL" (white text) is displayed and the card
slot status indicator lights up in green before you
remove the card.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
When the [POWER ON/OFF] switch is turned off
0
during recording or recording pause, recording
stops and power is cut off after a clip is
generated.
If the power is cut off due to low battery power,
0
a proper clip may not be generated.
93
Special Recording