Field Controls CUV Series Manual page 8

Generic Product Kit
The Generic Product Kit contains the instruction manual, tie wraps, access panel warning label, UV Lamp
installation label and lamp cleaning kit.
Use the lamp cleaning kit which consists of an alcohol pad to wipe down the UV lamp, if you touch lamp
glass surface with your hand or body. The oils from your hand or body can cause premature lamp failure if
not cleaned off of lamp surface.
Install the Access Panel Label Warning to the outside surface of the removeable access panel of the appli-
ance. This should be the same access panel where the Electrical Interlock Switch assembly is installed to
deactivate/ power down UV product when panel is removed.
Fill‐in installation date or in service date for the UV Lamps on the UV Lamp Installation Label using
permanent marker and affi x label some place near the UV Lamps access panel as a reminder to replace
the lamps every two (2) years.
The additional tie wraps are used to:
1. Secure Power Enclosure incoming power cable (SO Type Cable) to electrical panel connection,
2. Secure UV Lamp Cables,
Refer to Diagram 1 for General Wiring Diagram for xUV-11xxxx model products and Diagram 2 for xUV-
15xxxx model products.
P/N 780108800 Rev A 10/22 page 8 of 20