Baileigh Industrial TS-1040P-30-V2 Operator's Manual page 32

If adjustment is required:
1. Remove the table insert.
2. Loosen the lock handle (A) and remove the riving
knife, making a note as to which direction the riving
knife needs to be moved to align it with the saw
blade.
3. Using a 3mm hex wrench, make adjustments to
any of the four set screws (D) accessible through
openings located in the corners of the floating
clamp block (E).
4. If necessary, repeat the above procedure.
5. The distance of the riving knife from the gear rim must be between 3mm and 8mm.
measured radially through the center of the saw spindle.
Note: The highest point of the riving knife must be set beneath the topmost teeth
on the blade.
29
29