Table of Contents
Advertisement
Extension Wings
1. Remove the red shipping bracket (A) securing the
electrical box to the table. The bracket will not be
used again for normal operation.
2. Carefully allow the electrical box to hang by the
cords until ready to fasten to the front of the table
during the installation of the fence rails.
3. Inspect the extension wings and main table
mating surfaces for burrs or foreign materials
that may inhibit assembly.
4. Remove and retain the 7/16"-14x1-1/2" hex head
cap screw, 7/16" lock washer and 7/16" flat
washer from the main table edge.
5. The mating edges of the wings and the table
must be clean, smooth, and flat, use a wire brush
or file if necessary to clean up the edges, this step
will ensure that the wings mount properly to the main
table.
6. Loosely attach the wings to the main table with the
removed fasteners.
7. Place the straightedge across the extension wings
and main table to make sure that the extension
wings are flat to the full width of the table surface.
Use soft surface clamps to assist as needed.
• If the outside end of extension wings tilts down
or up, use a strip of masking tape to shim the
extension wing up or down.
• Shim the top (above the holes) if the table is tilted upward, and shim the bottom (below
the holes) if the table is tilted downward.
8. When the tables are aligned, and flat across the entire surface, fully tighten the three 7/16"
hex heads cap screws for each extension.
19
19
A
Advertisement
Table of Contents
