Table of Contents
Advertisement
INSTAllATION
Putting-up and levelling the machine
24
Putting-up and Levelling the Machine
When the instructions in the chapter "Preparations" have been followed there
should be no problems with the putting up and adjustment of the machine.
As standard the machine is provided with levelling pads (3, 4, 5 and 7). The level-
ling pads consist of an adjusting screw (11), a levelling plate (9) and a locking nut
(10).
After setting down the machine lower with the levelling screws (11) to the floor
clearance prescribed in the picture "Putting up and adjustment" of the machine.
The adjustment should be carried out before fitting the chip conveyor.
Securing brackets for transport must be removed.
Adjustment procedure
– Traverse the compound slide 1 in Z-direction as far as possible towards the
spindle (dismount tools if necessary).
– Open door at the back of the machine.
– Set a spirit level (6) on the Z-axis ball screw (see picture).
– Adjust machine with levelling elements (3, 4, 5 and 7) - accuracy longitudinal ±
0,1 mm/m.
In transverse direction it is sufficient to carry out rough adjustment,
for this the spirit level is set onto the machine frame (see picture).
– After the adjustment tighten the securing nuts on all levelling elements.
Securing against the floor is possible at the levelling elements (3) and
(4). (Refer to machine installation plan in the chapter "Working data")
11
10
9
Fig.: Putting-up and Levelling the Machine
Dim. A: min.10 mm, max.20 mm Floor clearance
4
2
3
1
Base
2
Machine main frame
3,4,5,7
Levelling elements
6
Spirit level
Transportation, Installation, Commissioning
5
6
8
7
1
8
Compound slide 1
9
Levelling plate
10 Securing nut
11 Adjusting screw
ABC
LL1602.10043 - 04.08.2014
Advertisement
Table of Contents
