Programming; Programming Menu; Access Code - Emerson Leroy Somer DIGISTART D3 User Manual

Safety Rating Mechanical
Information Data Installation
8.

Programming

The motor data parameters are critical to the correct operation of the soft starter's thermal model, and to the motor
overload protection. Always set Pr 1A to suit the motor's characteristics. The default settings of Pr 1B , 1C and 1D are
WARNING suitable for most applications. Consult the motor datasheet before changing these settings.
8.1

Programming menu

The Programming Menu lets you view and change programmable parameters that control how the Digistart D3 operates.
To open the Programming Menu, press the M button while viewing the monitoring screens.
To navigate through the Programming Menu:

to scroll through parameter groups, press the

to open a submenu, press the M button.

to view the parameters in a group, press the M button.

to return to the previous level, press the

to close the Programming Menu, press
To change a parameter value:

scroll to the appropriate parameter in the Programming Menu and press M to enter edit mode.

to alter the parameter setting, use the
one unit. If the button is held for longer than five seconds, the value will increase or decrease at a faster rate.

to save changes, press M . The setting shown on the display will be saved and the keypad will return to the parameter list.

to cancel changes, press
changes.
The Programming Menu contains the following sub-menus.
Table 8-1 Programming Menu structure
Quick Setup Menu The Quick Setup Menu allows you to select common applications and guides you through the
parameter setup process for these applications.
Standard Menu The Standard Menu provides access to commonly used parameters, allowing you to configure the
Digistart D3 to suit your application.
Advanced Menu The Advanced Menu provides access to all the Digistart D3's programmable parameters, allowing
experienced users to take advantage of advanced features.
Setup Tools Setup Tools provides access to functions to save the current parameter settings to a file, load
parameters from a previously saved file, or reset all parameters to default values.
Simulations Simulations allows you to simulate operation of the soft starter, including input and output functions.
I/O State I/O State provides access to information on the current state of the analog and digital inputs and
outputs.
Logs The Logs Menu provides access to the Trip Log and Event Log.
Counters The Counters Menu provides access to information on the starter's operating history.
8.2

Access code

Critical parameters (parameter group 15 and higher) are protected by a four-digit security access code, preventing unauthorised
users from viewing or modifying parameter settings.
When a user attempts to enter a restricted parameter group, the keypad prompts for an access code. The access code is requested
once for the programming session, and authorisation continues until the user closes the menu.
To enter the access code, use the
four digits match your access code, press M . The keypad will display an acknowledgement message before continuing.
Enter Access Code
0###
M
Access Allowed
SUPERVISOR
To change the access code, use Pr 15A .
The simulation tools and counter resets are also protected by the security access code.
The default access code is 0000.
Digistart D3 User Guide
Issue: F
Electrical Keypad Quick Start
Installation and Status Commissioning
or
button.
repeatedly.
and
. The keypad will ask for confirmation, then return to the parameter list without saving
and M buttons to select a digit, and the
Operation Programming Diagnostics Application
button.
buttons. Pressing or once will increase or decrease the value by
and
Technical Maintenance Options
Examples Data
buttons to change the value. When all
45