Microtek ScanMaker 3700 Supplementary Manual page 2
Microtek scanner configuration utility
Hide thumbs
Also See for ScanMaker 3700:
- Supplementary manual (12 pages) ,
- Install manual (4 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Launching and Exiting the MSC
utility
Launch your Microtek Scanner Configuration (MSC) utility by:
Double-clicking the Microtek Scanner Configuration (MSC) icon
from the desktop.
Pressing the Cancel/Setup button on your scanner (if your scanner is
not working).
To exit the Microtek Scanner Configuration (MSC) utility:
Click the Exit
the bottom-right corner for the Mac) of the Microtek Scanner
Configuration (MSC) panel.
Using the Microtek Scanner Configuration (MSC) utility
file:///D|/msc/WebHelp/Launching_exiting_MSC.htm [8/20/03 2:27:15 AM]
button located at the top-right corner (OK button on
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ScanMaker 3700 and is the answer not in the manual?
Questions and answers