Installing Software; Connecting The Scanner - Microtek ArtixScan 2020 User Manual

From the two screens, you have seen the
available IRQ and I/O address for use with the
AVA-2903E interface card.
If the message "aic78xx" is not listed on the
screen, indicating the SCSI driver is not
installed; refer to the Troubleshooting section.

4. Installing software

1. Launch Windows NT 4.0, log in as
Administrator.
2. Insert the Microtek CD-ROM into your CD-
ROM drive. The Microtek Scanner Software
installer should come up automatically, and list
the available software for you. Click on each
software program in the order they appear on
your screen to install all software components.
Note: If the Microtek Scanner Software Installer is
not automatically displayed on the screen, click
Start, select Run and type d:\cdsetup (where d: is
the drive letter of your CD-ROM).
Step 1 Install Microtek ScanWizard Pro
Microtek ScanWizard Pro is the TWAIN driver
used for ArtixScan 2020 to communicate with
various applications. With the scanner connected,
you can run ScanWizard Pro independently or
acquire it by another application program.
1. Click Microtek ScanWizard Pro . The
ScanWizard Pro setup program should start
running.
2. When you have finished the above selections,
program will copy the files to the folder
"Microtek ScanWizard Pro for Windows"
under Program file directory.
3. Next, you are prepared to install Microtek
Color Matching System (CMS) setup program.
Fore more details on CMS installation, refer to
the step 3 on page 3
Step 2 Install software application
The bundled image editing, OCR, and other
applications you receive depend on the scanner
model you purchased. Click each option on the
installer screen to install the software.
Step 3 Install documentation reader
Click Adobe Acrobat Reader, then follow screen
instructions until installation is completed. Acrobat
Reader is necessary for reading the manuals on
your CD-ROM.

5. Connecting the scanner

Make sure your scanner and computer are turned
off before connection begins. See Step 5 on page 5
to connect the scanner and computer.
25-pin connector
14
50-pin
connector
SCSI cable
Set the
terminator
switch to the
"ON"
position.