Using The 35Mm Filmstrip Holder - Microtek ArtixScan 2020 User Manual

3) Using the 35mm filmstrip holder

1. Insert the 35mm filmstrip to be scanned into
the 35mm filmstrip holder.
a) Push to open the 5-piece 35mm filmstrip
holder.
b) Place the 35mm filmstrip in the holder.
c) Pull to close the 5-piece 35mm filmstrip
holder.
For high-resolution scanning
filmstrip into the holder in the area that labeled
"HIGH RESOLUTION" on the holder.
2. Pull the transparency tray out a little, then
place the 35mm filmstrip holder into the
transparency tray.
Note: Push the holder back to place, make sure it is
firmly seated in the transparency tray.
3. Gently push the transparency tray back in.
24
: Insert the 35mm