Adjustment Procedure; Preparation - Icom IC-F2000 Service Manual

SECTION 4

4-1 PREPARATION

■ REQUIRED EQUIPMENT
EQUIPMENT
Programming CS-F2000 PROGRAMMING
software SOFTWARE (Revision 1.31 or later)
Output voltage:
DC power supply
Current capacity:
Measuring range:
RF power meter
Frequency range:
(50 Ω terminated)
SWR:
Frequency range:
Modulation analyzer
Measuring range:
Attenuation:
Attenuator
Capacity:
Audio generator Frequency range:
(AG) Output level:
■ SAVE THE PROGRAMMING DATA
• Adjusting the transceiver will change the programming setting.
• Before adjusting, save the programming data of the transceiver with the programming software.
After adjusting, write back the programming data.
★
■ CONNECTIONS
Standard signal generator
–20 to 90 dBµ
(–127 to –17 dBm)
Spectrum analyzer
Up to 3 GHz
Modulation analyzer
30~600 MHz/0 to ±10 kHz
IC-F2000/IC-F2000S/IC-F2000T

ADJUSTMENT PROCEDURE

GRADE AND RANGE
7.5 V
More than 2 A
0.1~10 W
100~600 MHz
Less than 1.2 : 1
30~600 MHz
0 to ±10 kHz
30 dB or 40 dB
More than 10 W
300~3000 Hz
1~500 mV
to the antenna connector
CAUTION!
NEVER transmit while
the SSG is connected to
the antenna connector.
Attenuator
30 dB or 40 dB
Loose couple
RF power meter
0.1~10 W/50 Ω
Frequency
counter
Rear panel view
Ammeter
0 to 2 A
DC power supply
7.5 V/2 A
EQUIPMENT
Programming cable OPC-478UC
Standard signal
generator (SSG)
AC millivoltmeter
Frequency counter
Distortion meter
External speaker
Ammeter
Spectrum analyzer Measuring range:
To [MIC]
To [SP]
IC-F2000/IC-F2000S/IC-F2000T
4-1
GRADE AND RANGE
Frequency range: 0.1~600 MHz
Output level: −20 to 90 dBμ
(−127 to −17 dBm)
Measuring range: 10 mV to 10 V
Range: 0.1~600 MHz
Accuracy: ±1 ppm or better
Measuring accuracy: 3% or less at 1 kHz
Input level: 50 mV to 10 V
Input impedance: 8 Ω
Rated input power: More than 1 W
Measuring range: 0 to 2 A
Up to 3 GHz
to USB port
OPC-478UC
JIG cable 1: See the illustration
shown on page 4-2.
JIG cable 2: See the illustration
shown on page 4-2.
PC