Section 5 Adjustment Procedure; Preparation - Icom IC-F8101 Service Manual

SECTION 5.

5-1 PREPARATION

M REQUIRED EQUIPMENTS
EQUIPMENT
CS-F8100 CLONING SOFTWARE
Cloning software
(Revision 1.0 or later)
Measuring range:
RF power meter
Frequency range:
(50 terminated)
SWR:
AC millivoltmeter Measuring range:
Audio generator Frequency range:
(AG) Output level:
Voltage:
DC power supply
Capacity:
M GENERAL CONNECTION
DC
AMMETER
(0.1–40 A)
−
⊕
Red
−
Black
The tests described in Section 5 should be measured and adjusted the with above test equipment, or a radio
tester. The adjustments are described with the radio tester.
ADJUSTMENT PROCEDURE
GRADE AND RANGE
0.1–300 W
0.1–50 MHz
Less than 1.2 : 1
10 mV to 10 V
300–3000 Hz
1–500 mV
13.8 V
More than 40 A
3.5(d) mm monoral plug
AC MILLIVOLT METER
(10 mV to 10 V)
– +
EXT. SPEAKER
(2 W/8 Ω)
+
–
DC power supply
(13.8 V/40 A)
−
⊕
Fuses
30 A
−
⊕
Black
Red
Supplied DC cable
NEVER TRANSMIT while an SSG is connected.
EQUIPMENT
Frequency range:
Standard signal
Output level:
generator (SSG)
Frequency range:
Frequency counter Frequency accuracy: ±1 ppm or better
Input level:
Input impedance:
Dummy load
Capacity:
External speaker SP-35L
Voltmeter Measuring range:
Ammeter Measuring range:
SP
RF POWER METER
(300 W/50 Ω)
FREQUENCY COUNTER
DUMMY LOAD
(0.1–50 MHz)
(50 Ω/300 W)
(Loose Coupling)
STANDARD SIGNAL GENERATOR
(0.1–50 MHz)
5-1
GRADE AND RANGE
0.1–50 MHz
–20 dBµ to 90 dBµ
(–127 to –17 dBm)
0.1–50 MHz
Less than 1 mW
50 
More than 300 W
0.1–10 V
0.1–40 A
ANT
USB
ACC
ATU