Icom IC-F1000 series Instructions

INSTRUCTIONS
VHF TRANSCEIVERS
Iç-F1000 series
UHF TRANSCEIVERS
Iç-F2000 series
SUPPLIED ACCESSORIES
q w e
r t
PANEL DESCRIPTION
[ROTARY
SELECTOR]
ANTENNA CONNECTOR
[VOL]
[Emer]
LED INDICATOR
Speaker
SPEAKER-
[PTT]
MICROPHONE
JACK
[UP]*
Microphone
[Upper]*
FUNCTION DISPLAY
(Dealer assignable)
(LCD)*
[DOWN]*
[P0], [P1], [P2], [P3]*
[Lower]*
(Dealer assignable)
(Dealer assignable)
10-KEY PAD*
The illustration is for the 10-key type transceivers.
* Depending on the transceiver version
Thank you for purchasing the IC-F1000 series
vhf
or IC-F2000 series
transceivers uhf transceiv
.
ers
READ ALL INSTRUCTIONS carefully and com-
pletely before using the transceiver.
q Battery pack (BP-279)
w Battery charger (BC-213)
e Belt clip (MB-133)
r AC adapter* (for the battery charger)
t Flexible antenna*
* Not supplied, or the shape is different, depending on
the transceiver version.
There are three types of transceivers in the IC-F1000
and IC-F2000 series.
IC-F1000/F2000: Non-Display Type
IC-F1000S/F2000S: Simple Type
[LCD + 4 keys (P0–P3)]
IC-F1000T/F2000T: 10-Key Type
[LCD + 4 keys + 10-Key Pad]
D About the LED Indicator
• Lights red while transmitting.
• Lights green while receiving a signal, or when the
squelch is open.
• Lights or blinks orange when the matched 2-Tone or
5-Tone is received, depending on the presetting.
• You should charge the battery when the indicator
slowly blinks green.
• You must charge the battery when the indicator
blinks green fast.
D About the Speaker microphone jack
CAUTION: Only when the jack cover or the option-
al HM-168LWP is attached, the transceiver meets
IP67 requirements for dust-tight and waterproof pro-
tection.
-
q SIGNAL STRENGTH INDICATOR
Displays the relative receive signal strength level.
w LOW POWER ICON
Appears when low output power is selected.
• When the battery charge decreases to a set level, low
power is automatically selected.
e AUDIBLE ICON
Appears when the channel is in the 'audible' (un-
➥
muted) mode.
➥ Appears when a matched 2-Tone or 5-Tone is re-
ceived.
r COMPANDER ICON
Appears when the Compander function is ON.
t SCRAMBLER ICON
Appears when the Voice Scrambler function is ON.
D Rapid charging the supplied BC-213
The BC-213
desktop charger
ion battery pack.
The BC-213 is used with an AC adapter or the CP-23L
(purchase separately).
cigarette lighter cable
• Charging time of the BP-279
Approximately 2 to 3 hours
CAUTION: STOP charging, if the charge indicator
lights orange and green alternately.
NOTE: Charge the battery within the specified tem-
perature range of +10°C to +40°C (+50°F to +104°F).
Otherwise, the charging time will be longer, but the
battery will not reach a full charge. While charging,
at a point after the temperature goes out of the spec-
ified range, the charging will automatically stop.
D Rapid charging the BC-214
The BC-214 (purchase separately) can
multi charger
simultaneously charge up to 6 Li-ion battery packs.
The BC-214 is used with BC-157S
chase separately) or the OPC-656
(purchase separately).
• Charging time of the BP-279
Approximately 2 to 3 hours
For more information about Icom accessories,
please read the "OPTIONS" printed on the reverse
side of this instruction sheet.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
FUNCTION DISPLAY
q w e r t y u i
o
!0
y BELL ICON
Appears or blinks when a matched 2-Tone or 5-Tone
is received, depending on the presetting.
u SCAN ICON
Appears or blinks while scanning.
i KEY LOCK ICON
Appears when the Key Lock function is ON.
o BATTERY INDICATOR
Displays the remaining battery charge.
Blinks when the battery charge decreases to a set
level.
!0 ALPHANUMERIC READOUT
Displays messages such as channel text.
BATTERY CHARGING
AC adapter
(A different type, or no
rapidly charges the Li-
AC adapter is supplied,
depending on the trans-
ceiver version.)
CP-23L
(for 12 V cigarette
lighter socket) can
be used instead of
the AC adapter.
Battery Transceiver
pack
(pur-
ac adapter
dc power cable
BC-214
Turn OFF the Power
Battery
pack
Transceiver
Charge indicator
• Lights orange
while charging.
• Lights green when
charging is completed.
BC-213
Turn OFF
the power
BC-157S
OPC-656
Connect to a DC
power supply:
12 to 16 V, at least 7 A
Red line: +
Black line: _
A-7122H-2EX-e Printed in Japan
© 2014 Icom Inc.