Marcy REVOLUTION CYCLE Owner's Manual page 8

STEP 2
A.) Insert the Handle Post (#3) into the front opening on Main Frame (#1). Use the M16 Lock Knob
(#19) to hold the Handle Post at selected height. And lock the Handle Post (#3) by using M8 x
½" Lock Knob (#43).
B.) Attach the Handle (#2) to the Handle Post (#3). Secure them together with one M10 L-shaped
Lock Knob (#13) and Handle Sliding Block (#10) (which was pre -fitted inside of the tube).
C.) Attach two Elbow Supports (#6) into the split on the handle (#2), secure each of them with one
Rubber Spacer (#25) , one R29 Arc Washer (#7) and one M6 Knob (#18).
D.) Insert the Seat Post (#4) into the opening on Main Frame. Use the M16 Lock Knob (#19) to hold
the Seat Post at selected height.
E.) Flip over the Seat Pad (#14). Insert the tube on the Seat Support (#5) into the open slot and
securely fasten the two Nuts to secure the Seat Pad to the tube.
F.) Insert the Seat Support (#5) through the open slot on Seat Post. Use the M10 Seat Lock Knob
(#29) to hold the Seat at selected position.
© IMPEX INC. 7 www.marcypro.com