Installation Menu: Initializing The E8 Controller - Watts AERCO Modulex EXT Commercial Series User Manual

Modulex EXT Commercial Series Boilers User Manual
CHAPTER 6: Operation of the E8 Controller

6.1 INSTALLATION MENU: INITIALIZING THE E8 CONTROLLER

Each time power is applied to the boiler and the E8 controller cover (Figure 7-1) is opened, the
INSTALLATION Menu is displayed once (only). These values MUST be entered in order to
initialize the boiler for operation. Once the values grouped here have been entered and
accepted, the controller is initiated and operatable and may be configured for your boiler
installation. To re-enter the INSTALLATION menu, cycle the boiler power and open the cover
again.
To initialize the E8 Controller, set the following values in the INSTALLATION Menu:
•
Set the parameters: ENGLISH, HOUR, YEAR, MONTH, and DAY.
•
Leave the BUS – ID HS parameter blank.
•
Remaining parameters are already set and do not require any entry.
WARNING
Menu selections shown are
the factory default settings.
Refer to GF-115-C for the
complete menu selections.
Page 88 of 144
09/15/2017
Figure 6-1: INSTALLATION Menu
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Phone: 800-526-0288
OMM-0095_0H
GF-139