High Altitude Conversion Label - Watts AERCO Modulex EXT Commercial Series User Manual

Modulex EXT Commercial Series Boilers User Manual
CHAPTER 4: Installation Instructions
TABLE 4-7: MODULEX EXT FA (Factory) Parameters Set in PARAM HS
xx Menu
PARAMETERS
FAN MOD IGN
FAN MOD STBY
FAN MAX (FH)
FAN MIN (FL)
MAX DIFF PRO
MIN FLOW PRO
MIN FLOW RAT
BOIL HYS
BOIL SLP LIM
BOIL P VAL
BOIL I VAL
BOIL D VAL
PUMP OVERRUN
PUMP MIN MOD
CAP FLOW RATE
FAN P VAL
FAN I VAL
FAN SLP
FAN SLP POS
FAN SLP NEG
FAN START PW
FAN ADAPT
RESTARTS
SW NO
SW RWV

4.36 HIGH ALTITUDE CONVERSION LABEL

After calibration of the unit from Normal Altitude (0 - 2,000 feet) to High Altitude (2,000 – 4,500
feet) operation, the label below must be filled out with the appropriate information and applied to
the unit in close proximity to the rating label. If the unit is calibrated again for normal altitude
operation, the label should be removed.
Figure 4-32: High Altitude Conversion Label
Page 72 of 144
09/15/2017
FOR LOW ALTITUDE
80
26
84
31
30
00
200
5
10
25
12
00
05
----
----
04
08
----
----
----
----
----
Software N°
Software Revision
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Phone: 800-526-0288
MODULEX EXT
FOR HIGH ALTITUDE
No Change
No Change
100
No Change
No Change
No Change
No Change
No Change
No Change
No Change
No Change
No Change
No Change
No Change
Software N°
Software Revision
28
----
----
----
----
----
----
----
OMM-0095_0H
GF-139