Aeotec MultiSensor 7 Quick Start Manual page 12

24/11/2022, 15:52
Setting
0
1
Parameter 2: Motion Retrigger Time
Presence re-detection time set in second to allow motion sensor to reset timeout of motion sensor. In this time, the motion sensor can not be triggered again. If this
value reach zero, the timeout configuration value set by Param3 will be reset. This setting value must always be less than timeout configuration.0 - disable1~3600
- timeout set in seconds
Size: 2 Byte, Default Value: 30
Setting
30 - 3600
Parameter 3: Motion Untrigger Time
Timeout configuration set in second for motion sensor to send no trigger status.
Size: 2 Byte, Default Value: 240
Setting
30 - 3600
Parameter 4: Motion Sensitivity
Set the sensitivity of motion sensor.
Size: 1 Byte, Default Value: 11
Setting
0
1 - 11
Parameter 5: Motion Report Type
Set which command class will be sent when the motion sensor is triggered or detriggered.
Size: 1 Byte, Default Value: 2
https://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZWA024&cert=ZC12-20120147
https://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZWA024&cert=ZC12-20120147
Description
Disable
Enable
Description
timeout set in seconds
Description
timeout set in seconds
Description
Disable
sensitivity range
12/37