Table of Contents
Advertisement
ADJUSTING THE DUST BLOWER
For best results, the dust blower tube (Fig. 4, 3)
should be adjusted to direct air at both the
blade and the workpiece.
POWER SWITCH & SPEED CONTROL
KNOB
1. To turn the saw on, flip the I/O switch (Fig. 4, 1)
to I. When first starting the saw, it is best to move the speed control knob (2) to the
middle speed position.
2. Turning the control knob. Turning it towards H increases speed; turning it towards L
reduces speed.
3. To turn the saw off, flip the I/O switch back to O.
WARNING
!
To avoid injury from accidental start-ups, always turn the switch OFF and unplug the scroll
saw before moving the saw, replacing the blade, or making adjustments.
FREEHAND CUTTING
1. Lay out desired design, or secure design to the workpiece.
2. Raise the blade guard foot by loosening the height adjustment knob.
3. Position the workpiece against the blade and place the blade guard foot just above
the top surface of the workpiece.
4. Secure the blade guard foot by tightening the height adjustment knob.
5. Remove the workpiece from the blade prior to turning the scroll saw ON.
6. Slowly feed the workpiece into the blade while holding the workpiece securely
against the table.
7. When cutting is complete, move trailing edge of the workpiece beyond the blade
guard foot. Turn the switch OFF.
ADJUSTMENTS & OPERATION
1
2
FIGURE 2
11
4
3
FIGURE 3
1
2
3
FIGURE 4
Advertisement
Table of Contents
